Trusted HVAC Company in Hutto, TX

Returned to complete previously scoped repairs on the air handler. Inspected the evaporator coil section and found condensation on the drain pan and cabinet interior, along with worn, deteriorated refrigerant line insulation and a rust stain near the pan. Inspected the blower assembly and found dust and dirt buildup on the blower wheel and housing, which can reduce airflow and system efficiency. Documented the findings with photos.

Performed a full flush on both water heaters in a dual-unit setup, draining sediment and mineral buildup from each tank and discharging the flush water to the exterior drain point. Sediment and scale residue were removed from both units and the systems were returned to normal operation after refill and purge of air from the lines.

Returned to site to complete the installation of the York condenser unit, finalizing the refrigerant line set connections at the unit's service valves and wall penetration, and sealing and insulating the line set. Verified the unit is level on its concrete pad with the electrical whip routed to the disconnect, and confirmed the condensate drain piping is routed clear of the pad. Installed in a coastal environment with salt-exposure labeling present, and the unit shows no visible damage, rust, or frost.

Responded to a reported burning smell from the HVAC system and inspected the unit and air filter. Found the filter heavily clogged with dust and debris, restricting airflow, and observed fibrous, web-like buildup with powdery residue on an interior surface, indicating contamination that may be contributing to the odor. Documented findings with photos and advised on filter replacement and further cleaning to restore proper airflow and system performance.

Responded to a reported yard leak with loss of water service to the home. Performed diagnostics and located the leak at a previous repair location on the water supply line, and identified the main water cut-off valve at the front of the property. Also noted that a leaking water softener introduced debris into the plumbing system, contributing to restricted flow inside the home. Presented repair options, including a line repair with new cut-off valve installation and a follow-up diagnostic.

Performed seasonal maintenance on a single-system split HVAC installation with the air handler located in the attic. Inspected the air handler and accessible ductwork, confirmed the work area was clean and accessible, and verified the condition of the filter and return components. At the outdoor condenser, used a digital probe thermometer to take temperature readings for evaluating system performance and cooling operation.