SALT Service Co., Your HVAC Company in Austin

Responded to warranty callback for dangling energized conductor discovered in basement following completed whole-home rewire project. Upon arrival, located exposed hot wire hanging from upper basement rafter near unfinished framing area with reflective insulation. Verified wire was energized using voltage tester and traced circuit back to source panel. Properly terminated the loose conductor, secured all wiring to structural members per NEC standards, and installed appropriate wire management to prevent future displacement. Inspected surrounding areas of recent rewire work to ensure no additional loose connections or unsecured conductors were present. All electrical connections tested and verified safe, with no voltage present on any exposed surfaces. Work area left clean and secure.

Completed spring maintenance on 7-year-old Carrier HVAC system located in interior closet. Performed comprehensive system inspection including air handler, blower assembly, and all electrical connections. Inspected condensate drain pan and reapplied drain pan treatment as previous application from fall maintenance had reached its 6-month service interval. Verified wiring connections at indoor unit showed no progression of corrosion previously noted in October 2025. Replaced IAQ LPD filter at Dynamic Air Quality Solutions unit installed in attic space. Checked refrigerant lines and verified proper operation of all system components. Confirmed ductwork sealing from previous service remains intact with mastic and flex tape in good condition. System operating within normal parameters with no issues reported.

Completed indoor lighting installation in bedroom with no existing power source. Assessed ceiling structure and identified appropriate circuit to tap for new lighting fixture. Ran electrical wiring from power source through ceiling to fixture location, installed junction box, and mounted new light fixtures per specifications. Verified all connections, tested operation, and confirmed proper functionality of installed lighting system.

Completed comprehensive plumbing maintenance inspection on 5-year-old residential property with original fixtures and single gas tank water heater located in garage. Performed thorough evaluation of kitchen plumbing system, including inspection of garbage disposal unit, mounting assembly, P-trap configuration, and associated drainage connections. Assessed exterior water service infrastructure by accessing underground meter pit and inspecting water meter, shut-off valves, supply lines, and connection integrity. Documented all plumbing components and system conditions with photographic records for maintenance history reference.

Responded to callback for recurring dryer circuit breaker tripping with burning smell on second floor laundry room in 3.5-year-old residence. Upon arrival, accessed main electrical panel and performed comprehensive diagnostic evaluation of the 20-amp branch circuit serving the dryer, which had been previously serviced. Conducted voltage testing, load analysis, and thermal inspection of breaker connections and bus bar contacts. Identified compromised breaker with signs of internal degradation and overheating at terminal connections. Removed faulty circuit breaker and inspected wire terminations for heat damage and proper torque specifications. Installed new 20-amp Square D circuit breaker with proper wire landing and torque settings per manufacturer specifications. Verified proper wire gauge and insulation integrity throughout the branch circuit run. Tested dryer operation under full load conditions to confirm breaker held without nuisance tripping and verified no abnormal heating at pa

Completed comprehensive electrical maintenance inspection on 2007 residential property with 2,282 square foot building area. Performed whole-home electrical system evaluation including detailed inspection of main service panel located on exterior side wall, verified proper operation of all circuit breakers, tested connections at main disconnect and meter assembly, and confirmed grounding system integrity throughout the panel. Inspected exterior electrical service equipment including main panel box, junction boxes, and meter assembly with associated conduit connections. Verified all circuit breaker labels were legible and properly identified, examined wire terminations and connections for signs of overheating or loose connections, and ensured proper separation of neutral and ground conductors consistent with current electrical code requirements. All circuit breakers tested for proper mechanical operation and appropriate trip response. Grounding conductors and bonding connections inspect