Trusted HVAC Company in Hutto, TX

Completed spring recurring maintenance on two HVAC systems in a 27-year-old residential property—one unit located in the main house utility closet and one in the guest house attic. Performed comprehensive system inspections including temperature differential readings, which measured 75.5°F at the main house return grille and 74.5°F in the guest house attic location. Both systems were previously noted for slight over-amping conditions during the fall maintenance visit; followed up on the recommended hard start kit installation for the main house unit that was previously offered under warranty to address the compressor amperage issue.

Responded to circuit issue affecting two back rooms in 13-year-old residence. Performed comprehensive inspection of main electrical panel located in garage, examining all circuit breakers, bus bars, and wire connections. Identified and reset tripped breakers serving affected rooms, verified proper breaker operation and holding capacity. Inspected all wire terminations, connections, and circuit integrity within panel. Documented panel condition with photographs showing Square D breaker configuration and wiring arrangement. Previous service history indicated similar tripped breaker condition in 2022 with possible utility-side surge as contributing factor. All breakers tested and reset successfully, circuits restored to proper operation.

Completed spring member maintenance on 1-year-old Friedrich Breeze 4-ton heat pump system located in attic of 2,720 sq ft residence. Performed comprehensive system analysis including electrical component testing, refrigerant level verification, condenser coil cleaning, and drain line flushing. All electrical connections tested within manufacturer specifications and refrigerant charge confirmed at proper levels. During inspection, discovered significant dust and debris accumulation throughout supply ductwork interior, with heavy particulate buildup on all duct surfaces and baffles. Documented condition with thermal imaging showing supply air temperature of 29.1°F at register, confirming proper cooling operation despite ductwork contamination. Insulation surrounding ductwork appears intact but shows signs of dust infiltration. Given system's history of post-installation airflow issues, duct leaks, and air handler replacement, the excessive duct contamination in a 1-year-old system is

Installed a new 30-amp dedicated electrical outlet on the exterior of the residence to provide power for an RV camper connection. Work included running appropriate gauge wiring from the main electrical panel, installing proper conduit protection, and mounting a weather-resistant 30-amp receptacle with NEMA TT-30R configuration to meet RV power requirements. Installation was completed in compliance with NEC standards for outdoor receptacles and RV service connections, with all connections properly grounded and secured.

Completed spring maintenance on 2020 Trane single-zone system located in second floor closet. Performed comprehensive inspection following previous biological growth remediation and Silver IAQ package installation. Measured static pressure readings at 0.02 inWC on both supply and return, indicating balanced airflow. Inspected evaporator coil and found fins clean with minimal dust accumulation; verified drain pan and condensate line clear with no signs of biological growth recurrence. Confirmed UV light operational and IAQ system functioning properly. Checked all electrical connections, tested zone board operation following previous replacement, and verified thermostat programming. Outdoor unit mechanical and electrical components inspected and found in good condition. All 17 registers verified for proper airflow. System operating efficiently with no issues identified.

Completed spring maintenance on Friedrich 3 Ton 14 SEER 2 straight cool system located in attic. Performed comprehensive inspection of condenser unit, evaporator coil, and furnace, verifying proper operation following first full cooling season since installation. Checked refrigerant charge, confirmed adequate levels with no signs of leakage. Inspected electrical connections, tested capacitor values, and verified proper amperage draw on compressor and blower motor. Cleaned condenser coils and checked for proper airflow. Measured temperature differential across evaporator coil at 54°F, indicating optimal system performance. Changed air filter and inspected ductwork for proper sealing and insulation integrity. Tested thermostat operation and cycling. All components operating within manufacturer specifications with no deficiencies noted. System performing efficiently with no service recommendations required at this time.