Trusted HVAC Company in Hutto, TX

Responded to no cooling complaint on one-year-old Bryant Endeavor 3-ton system located in attic. Upon arrival, confirmed air handler was operating but condenser unit was not running. Inspected outdoor unit and found evidence of significant water damage and rust staining on exterior wall below condensate drain, indicating potential drainage issues. Performed diagnostic evaluation of electrical components, refrigerant circuit, and thermostat operation. System had previous warranty service in November for blown 3-amp fuse on air handler, which was documented and considered during troubleshooting. Verified thermostat settings and confirmed proper communication between indoor and outdoor units. All findings documented with photos showing exterior wall damage and thermostat display for warranty consideration given system age.

Completed spring maintenance service on a 4-year-old HVAC system located in the attic of a 3,000 square foot residential property. System was reported to be operating properly prior to service visit. Attic workspace was clean, safe, and accessible for thorough inspection and maintenance procedures. Performed comprehensive seasonal maintenance inspection on single cooling system. Verified thermostat operation and calibration using Honeywell Home ProSeries digital unit. Confirmed system was actively cooling with display showing 73°F current temperature against 65°F setpoint, with outdoor temperature reading 85.2°F. Thermostat showed "Cool On" status with fan set to continuous operation and WiFi connectivity enabled for remote monitoring capabilities. Accessed attic-mounted air handler and conducted detailed system evaluation. Measured and documented supply air temperature at 48.0°F using calibrated digital thermometer, indicating proper refrigerant charge and cooling performance. Inspe

Completed spring maintenance on 3-year-old HVAC system located in attic. Performed comprehensive system inspection including electrical connections, wiring harness, and control board components. Replaced air filters as requested. Inspected air handler unit and documented significant rust staining and corrosion on platform beneath unit, indicating previous or ongoing moisture exposure issues. Examined condensate drain lines and PVC piping for proper drainage. Verified all electrical connections secure with proper wire management and cable ties in place. Checked manufacturer labels and specifications. Documented evidence of water damage on surrounding surfaces and metal components. System currently operating within normal parameters. Recommend monitoring condensate drainage system and platform corrosion for potential future remediation to prevent equipment damage.

Responded to cracked electrical junction box in dining room of 13-year-old home with 10-foot ceilings. Accessed attic space above dining area and inspected damaged electrical box supporting lighting fixture. Replaced compromised junction box with new code-compliant unit, secured all electrical connections, and reinstalled fixture mounting hardware including support chains and conduit. Verified proper grounding, tested circuit functionality, and confirmed secure installation of all components.

Responded to service call for dual plumbing issues at residential property. Inspected water softener system with failed pump motor, standing water in tank, and inability to complete regeneration cycle. Unit suspected to be original to 2011 construction, approximately 15 years old and beyond typical service life. Evaluated pressure reducing valve (PRV) located at front of property causing reduced water pressure throughout home. Documented equipment conditions with diagnostic photography and provided homeowner with assessment and replacement options for both failed components.

Completed comprehensive plumbing maintenance on 4-year-old residential gas tank water heater including tank flush, water quality testing, system pressure verification, and inspection of all valves and plumbing fixtures. Inspected toilet tank components including flush valve assembly, flapper mechanism, float adjustment system, and overflow tube—all found in proper working condition. Verified water supply pressure at exterior connection point using calibrated gauge, confirming system operating within normal parameters with all components functioning as designed.