Trusted HVAC Company in Hutto, TX

Completed spring maintenance on a 4-year-old HVAC system located in attic. Performed diagnostic testing using clamp meter to verify system amperage and temperature readings, which showed 86.5 on display indicating proper electrical operation. Inspected air handler unit and ductwork, noting significant dust and particulate accumulation throughout interior surfaces of plenum chamber and duct components. System operating without issues per customer report. All routine maintenance checks performed on single-system residential unit with accessible attic location.

Installed 6" flue pipe system through ceiling and roof structure, extending up to 10 feet vertically. Cut access openings in both ceiling and roof deck, properly routed metal duct through attic space, and sealed roof boot and ceiling penetration to ensure weatherproof integrity and code compliance.

Responded to electrical breaker tripping issue on 2019 electric tank water heater located in garage. Upon arrival, discovered water accumulation beneath unit that was previously concealed by protective cushions. Conducted thorough inspection of water heater and surrounding plumbing connections including water treatment system and filtration equipment. Identified active leak causing moisture intrusion near electrical components, creating short circuit condition and triggering breaker safety mechanism. Evaluated all plumbing connections, valve assemblies, and tank integrity to isolate leak source. Inspected water softener system, filtration tank with digital control head, expansion tank mounting, and associated piping network for potential failure points. Assessed condition of flexible supply lines, rigid copper connections, and pressure relief valve operation. Documented equipment configuration and leak location with photographic evidence showing utility room layout and plumbing infrast

Performed spring maintenance on a single 5-year-old HVAC system located in the attic of a 22-year-old, 2,355 square foot residence. Conducted comprehensive system inspection and diagnostics in response to previous concern regarding master bedroom running hotter than rest of house. Accessed attic-mounted unit and performed standard seasonal maintenance protocol. Conducted refrigerant charge verification using digital scale, measuring system pressures and weights to ensure proper charge levels. Display readings indicated system operating within normal parameters at 10 OM with CHILL mode active. Performed electrical diagnostics on outdoor condensing unit, testing voltage and amperage at the contactor and control board. Utilized digital multimeter to verify electrical connections, measuring 240V supply and 6.00 amp draw, confirming proper electrical operation. Inspected control wiring including thermostat connections, examining orange, yellow, and pink low-voltage wires within junction b

Responded to report of sewer odor in utility room that had been worsening over approximately one hour. Inspected washing machine plumbing connections and shutoff valves in recessed wall box. Identified issue with drain line or trap allowing sewer gases to enter the space. Addressed plumbing connections between appliance and drainage system to eliminate odor source and restore proper venting.

Completed comprehensive electrical maintenance service on 13-year-old residential property with 2,021 square feet. Performed whole home electrical inspection and tune-up on single breaker panel located in garage. Conducted thorough examination of 13-year-old electrical panel, inspecting all circuit breakers across both vertical columns, verifying proper operation and connections of multiple circuits throughout the distribution system. Evaluated main disconnect components and assessed wire management, noting the extensive conductor bundle configuration at the top of the panel enclosure. Inspected exterior electrical components including weatherproof outlet cover on brick exterior wall, confirming adequate protection from environmental exposure. All circuit breakers tested and found operational, with no immediate safety concerns identified during inspection.