Trusted HVAC Company in Hutto, TX

Conducted sales consultation for HVAC system replacement at residential property with existing beige condenser unit positioned against brick exterior wall. Assessed current equipment condition, discussed system upgrade options, and provided recommendations for new high-efficiency heating and cooling system to improve comfort and energy performance.

Completed installation of 3-ton, 14 SEER2 two-stage heat pump system including outdoor condenser unit and indoor air handler. Installed new supply plenum with 4-inch filter base and filter. Connected refrigerant lines with proper insulation and brass fittings to existing copper piping. Completed all electrical connections per manufacturer wiring diagram, properly capping and sealing unused wires. System includes 10-year parts warranty and 5-year labor warranty.

Responded to return service call for HVAC system not working and leaking, with conditions worsened since previous warranty visit. Upon arrival, conducted thorough inspection of the 8-9 year old system to identify source of increased water leakage and operational failure. Diagnosed primary drain line obstruction causing condensate overflow and secondary drain pan failure. Cleared condensate drain line blockage, inspected evaporator coil for additional issues, and verified proper drainage flow. Tested system operation, confirmed cooling cycle functionality, and monitored for any residual leakage. System restored to normal operating condition with no further water discharge observed at time of departure.

Completed fall maintenance service on two HVAC systems at property with main house system (3 years old) and garage apartment system (12 years old). Both units located in attic with clear access. Performed comprehensive inspection including electrical connections, terminal blocks, and control wiring. Inspected and documented condition of electrical components, including bus bar connectors and control circuit wiring. Verified proper wire connections on yellow, red, and blue control wires. Checked mechanical assemblies, mounting brackets, and securing hardware for proper installation. All systems operating within normal parameters following seasonal maintenance protocol.

Completed comprehensive electrical membership maintenance on 6,100 square foot estate property with three breaker panels located in garage. Performed thorough inspection of all electrical panels, circuit breakers, and meter connections, documenting panel conditions with detailed photography for service records. All panels found operational with standard residential circuit breaker configurations in serviceable condition.

Responded to service call for electrical power installation to backyard shed and additional outlet installation at 2007 residential property. Performed comprehensive assessment of existing electrical system, including inspection of main breaker panel and exterior meter enclosure. Panel inspection revealed mixed breaker configuration with standard black breakers and two yellow GFCI breakers currently installed. Verified panel capacity and available breaker slots to accommodate new circuit requirements for shed power feed. Examined exterior Milbank Type 3R meter enclosure with ONCOR FOCUS AXR-SD meter (Form 2S, CL200, 240V, 3W, 60Hz) to assess service entrance capacity and confirm adequate amperage for additional load. Documented existing panel labeling including kitchen GFCI and microwave disconnect circuits. Evaluated conduit routing options from main panel to proposed shed location in backyard and identified optimal pathway for new circuit installation. Assessed interior locations for