Trusted HVAC Company in Hutto, TX

Completed annual plumbing maintenance inspection on 2,210 square foot residential property. Inspected 5-year-old electric tank water heater located in second floor closet and confirmed unit operating within normal parameters with no leaks, corrosion, or performance issues detected. Evaluated dual-tank water treatment system with digital control heads, verified proper operation of softener/filtration equipment, and confirmed secure connections on blue supply lines and red-capped isolation valves. Inspected bathroom fixtures including bathtub drain assembly and sink faucet, noted minor surface staining and discoloration on sink basin consistent with age and mineral deposits but no functional defects requiring immediate attention. All plumbing systems tested and found operational with no active concerns identified during maintenance visit.

Responded to service call for kitchen sink leak and non-functional shower in secondary bathroom. Performed diagnostic assessment of kitchen sink plumbing connections and supply lines beneath granite countertop to identify source of leak. Inspected shower valve assembly, cartridge, and diverter mechanism in bathroom to determine cause of shower malfunction. Tested water pressure and flow at multiple fixtures throughout the residence to rule out supply line issues affecting both reported problems.

Responded to emergency call for vacant property with underground water line failure. Located and excavated two separate burst points in 19-year-old main water line running from city connection to residence in U-shaped configuration around rear of property. Replaced damaged sections of water line with new PVC piping, installed proper fittings and connections, and pressure tested system to ensure no additional leaks. Backfilled excavation areas and restored ground surface. Verified water softener system and interior plumbing connections remained functional following main line repair.

Responded to service call for recently installed Rheem Pro Terra 80-gallon hybrid heat pump water heater displaying alert message indicating T300 water leak sensor not installed, with exposed wiring also reported. Upon arrival, inspected unit model XE60T10H45U0 and verified alert condition on control panel. Addressed sensor installation issue and secured exposed wiring back into proper housing within unit enclosure. Verified all electrical connections were properly terminated and all safety components were functioning as designed per manufacturer specifications.

Completed spring HVAC maintenance on 12.5-year-old residential system located in attic. Performed comprehensive inspection of indoor air handler unit and outdoor condensing unit. Inspected ductwork interior for cleanliness and integrity, noting dust accumulation on duct surfaces and flexible duct connections. Measured electrical amperage draw on system components using clamp meter, recording 9.1 amp reading. Inspected capacitor connections and associated electrical wiring. Verified proper wire terminations on red, blue, and yellow conductors. Checked air filter condition and airflow pathways. System operating within normal parameters at time of inspection.

Responded to no hot water complaint on recently installed 30-gallon electric lowboy water heater. This marked the fifth service visit for the same issue since initial installation. Previous troubleshooting included multiple callbacks and electrical contractor evaluation with amp probe testing. Upon arrival, performed comprehensive diagnostic assessment of water heater operation, electrical connections, and heating element function. Inspected upper and lower thermostats, verified power supply at unit, and tested heating element continuity. Examined installation components including expansion tank, water connections, and drain pan assembly. Documented water damage and mineral deposits on floor surrounding unit base, indicating previous moisture issues. Verified proper wiring configuration and breaker sizing per manufacturer specifications. Photographed unit condition, specification plate, plumbing connections, and surrounding area showing floor deterioration and corrosion at base plate.