Trusted HVAC Company in Hutto, TX

Completed member maintenance inspection on 4-year-old single-zone HVAC system located in attic of 1,797 square foot residence. Verified thermostat operation and calibration, confirmed unit responding properly to temperature setpoint adjustments. Accessed attic-mounted equipment, performed visual inspection of all accessible components including previous repairs (contactor, dual capacitor, soft start kit installed in prior service). Measured ambient attic temperature at 55.9°F, confirmed adequate ventilation and insulation conditions surrounding equipment. System operating within normal parameters with no immediate issues identified at time of inspection.

Completed full system replacement of existing HVAC equipment with new 4 ton 14 SEER2 two-stage York heat pump system, including outdoor condensing unit and indoor air handler. Performed equipment swap-out utilizing existing ductwork, plenum, and thermostat wiring connections. Maintained existing Ecobee thermostat per customer preference. Connected and terminated all low-voltage control wiring at thermostat interface and outdoor unit. Installed refrigerant line set between indoor and outdoor components. Established electrical connections at outdoor disconnect and verified proper power supply. Performed system startup, refrigerant charge verification, and operational testing to confirm proper two-stage heating and cooling functionality. All equipment covered under 10-year parts warranty and 2-year labor warranty.

Completed comprehensive plumbing maintenance inspection on residential property. Performed thorough evaluation of 50-gallon American Standard gas water heater installed in utility closet, inspecting all connections, venting system, and operational components. Examined plumbing manifold assembly and associated PEX piping distribution system, verifying proper function of all valves and connections. All systems found operating within normal parameters with no immediate repairs required.

Responded to cooling capacity complaint on 3.5-year-old residential HVAC system unable to maintain 73°F setpoint, with indoor temperature stalling at 77°F under occupancy load. Performed diagnostic evaluation and utilized dual port manometer to measure static pressures and verify system airflow performance. Referenced manufacturer's indoor unit matchup and subcooling charge specifications to assess refrigerant charge levels and system operation parameters, addressing reported temperature imbalance between first and second floors.

Responded to service call for clogged condensate drain line on HVAC system at 30-year-old residence. Upon inspection, confirmed complete blockage in condensate tube causing drainage failure. Cleared obstruction from condensate line, verified proper drainage flow, and tested system operation to ensure normal function restored.

Performed air balancing service throughout the residence using calibrated ALNOR hood balancer to measure airflow at supply registers. Documented baseline readings and adjusted system dampers to achieve proper air distribution and optimize comfort levels in all conditioned spaces.