Trusted HVAC Company in Hutto, TX

Responded to backing up sewer line with damaged cleanout on service side. Performed video camera inspection revealing a PDC (post-demolition cap or similar obstruction) wedged approximately five feet into the exposed line. Camera inspection at depths of 9 feet and 33 feet confirmed the blockage location and condition of the 20-22 year old piping system. Documented interior pipe conditions showing obstruction and flow restriction requiring line clearance and cleanout repair to restore proper drainage function.

Completed annual preventive maintenance on Guardian 200W standby generator located in front yard. Performed comprehensive system inspection including visual examination of all internal components, control panel diagnostics, and verification of operational readiness. Noted fuel tank currently disconnected from unit during service. Inspected propane fuel system components including pressure regulator assembly, fuel lines, and tank-mounted equipment. Verified all electrical connections, battery condition, and control board functionality. Documented equipment condition through photographic records showing internal components and external fuel supply infrastructure.

Completed annual maintenance on air-cooled standby generator unit located behind garage. Performed comprehensive system inspection with unit access panel opened to evaluate internal components and mechanical systems. Verified proper operation of all critical systems including engine, alternator, cooling system, and control panel. Inspected electrical connections at utility meter panel and transfer switch, confirming secure terminations on all bus bars and proper labeling of neutral and ground connections. Checked battery condition, fluid levels, and belts for wear. Verified generator mounting stability on gravel pad foundation and inspected exterior housing for damage or deterioration. Tested automatic transfer switch functionality and confirmed proper voltage output. Cleaned debris from cooling louvers and ventilation openings. Inspected electrical conduit routing along building exterior for secure mounting and weather protection. System operating within manufacturer specifications wi

Completed routine member maintenance on 18-month-old HVAC system located in attic. Performed comprehensive inspection of evaporator coil assembly, noting moderate dust and debris accumulation on aluminum fins. Measured system temperatures and verified operational parameters using digital diagnostic equipment, with readings indicating normal performance levels. Inspected blower assembly and belt drive system, observing typical dust residue on components but confirming proper tension and operational condition. Checked condensate drain pan and drainage system for proper function. System operating within normal specifications at time of service.

Responded to customer complaint of insufficient hot water during shower use. Upon inspection, tested hot water flow and temperature at bathroom sink faucet to establish baseline water heater performance. Verified hot water supply was functioning properly at fixture closest to water heater. Proceeded to shower area to assess temperature and flow conditions at the reported problem location. Examined shower valve assembly, including chrome sliding bar shower system with handheld wand and temperature control valve. Determined issue was related to shower mixing valve requiring adjustment or potential replacement to restore adequate hot water delivery to shower fixture.

Responded to service call for 5-year-old HVAC system not maintaining temperature and running 9-10 degrees behind setpoint. Performed diagnostic testing using clamp meter to measure electrical readings at outdoor condensing unit, recording voltage of 381.1V and amperage of 26.9A. Documented system performance with photos showing meter readings and equipment condition for further analysis and repair recommendations.