Trusted HVAC Company in Hutto, TX

Performed air balancing procedures on HVAC system using dual port manometer to measure and verify proper airflow and static pressures across the unit. Additionally, removed weathered door strip from closet door per customer request.

Responded to service call for intermittent power loss affecting breakers and switches at 2005-built residence. Inspected exterior-mounted electrical panel containing GE brand circuit breakers with visible 20A ratings. Observed dust accumulation on breaker surfaces and connections, consistent with age and lack of previous maintenance history. Examined panel bus bars, wiring connections including red, blue, and gray conductors, and breaker toggle mechanisms for signs of failure or loose connections. Assessed exterior electrical infrastructure including main disconnect box, meter enclosure, and associated conduit runs. Provided temporary stabilization measures to address immediate power fluctuation issues until scheduled comprehensive repair appointment. Documented panel condition and exterior electrical components for follow-up service work.

Diagnosed residential HVAC system with low refrigerant charge and identified leaking evaporator coil as source of refrigerant loss. Documented existing equipment configuration including outdoor condensing unit and attic-mounted air handler with flexible ductwork for lead generation and system replacement proposal.

Responded to no cooling complaint on 5-year-old system located in attic. Accessed air handler unit and inspected evaporator coil assembly, noting accumulated dirt and debris on coil fins and in condensate drain pan. Performed electrical diagnostics using clamp meter to verify amperage draw and system operation. Checked refrigerant line connections and verified proper insulation on copper lines. Found coil contamination restricting airflow, causing reduced cooling capacity. Cleaned evaporator coil and drain pan, removing buildup affecting heat transfer efficiency. System restored to proper cooling operation with improved airflow across coil surfaces.

Completed electrical installation for Ring security system at 2005-built single-story residence for new homeowner. Installed dedicated circuits and exterior outlets to support Ring doorbell, security cameras, and floodlight fixtures on rear and front of home. Verified existing exterior lighting circuits and confirmed adequate power availability for new security devices. Installed Ring video doorbell at front entrance with proper low-voltage wiring and transformer connection. Performed comprehensive electrical panel inspection to assess surge protection capabilities and overall system condition. Recommended and discussed whole-home surge protection options to safeguard new security equipment and home electronics. All installations completed to manufacturer specifications and local electrical code requirements, with devices tested and confirmed operational before departure.

Responded to a not keeping up complaint on a 4-year-old HVAC system located in attic of 2,118 square foot home. Upon arrival, accessed attic-mounted air handler and performed diagnostic inspection of blower assembly and electrical components. Inspected blower wheel for debris accumulation and proper operation, photographed internal components including motor assembly and control board wiring connections. Verified electrical connections at control board, checked heat sink mounting and wire routing for proper installation. System had received maintenance in fall of previous year with no major issues noted at that time. Completed visual inspection of all accessible components and documented findings for customer review and recommendations.