Trusted HVAC Company in Hutto, TX

Replaced failed 3-year-old garbage disposal unit that had stopped working, causing kitchen sink to back up when dishwasher drained. Disconnected electrical supply, removed existing disposal from sink mounting assembly, cleared debris from cabinet area, and installed new disposal unit with proper electrical connections and plumbing integration including dishwasher drain line. Tested unit operation and verified proper drainage from both sink and dishwasher with no leaks or backups.

Responded to attic-located HVAC system with reported ductwork leakage on 7-year-old residential unit. Upon inspection, discovered deteriorated flexible ductwork with compromised outer vapor barrier and multiple sections showing torn reflective wrapping, exposing inner ribbed ducting material. Replaced damaged sections of flexible duct runs connecting to air handler unit. Properly sealed all connections with mastic and metallic foil tape to ensure airtight integrity. Verified existing plywood walkway provided safe access across attic joists for service work. Confirmed all replaced ductwork was properly supported and insulated to prevent future condensation issues and maintain system efficiency. System tested and operational upon completion.

Responded to electrical issues following a lightning strike to adjacent property. Homeowner reported flickering, dimming, and intermittent lighting in master bedroom, master closet, and entryway circuits. Performed comprehensive diagnostic assessment of the 3-year-old electrical system to identify potential surge damage. Inspected main electrical panel for evidence of transient voltage damage, loose connections, or compromised components resulting from the nearby lightning event. Examined all affected lighting circuits, tested voltage levels, and verified proper grounding throughout the system. Checked panel bus bars, circuit breakers, and neutral connections for signs of arcing or heat damage. Evaluated meter base and service entrance conductors for any surge-related deterioration. Documented panel configuration and wiring conditions through photographic evidence. Tested all affected lighting fixtures and switches in the master bedroom, master closet, and entryway to isolate potential

Completed comprehensive spring maintenance on a single-zone HVAC system located in attic space. Performed visual inspection of air handler unit and associated ductwork, verifying proper installation and secure connections. Checked electrical disconnect switch and fuse assembly, confirming proper operation and secure mounting. Inspected flexible ductwork for proper sealing, support, and insulation integrity throughout attic space. Verified air handler mounting, clearances, and access panel security. Tested system operation and confirmed normal heating and cooling functionality. Documented baseline condition of equipment for future reference, noting system is approximately one year old and operating within normal parameters. All components found in good working condition with no immediate concerns or repairs needed.

Responded to service call regarding whole home surge protector functionality after recent storm event caused damage to garage door opener. Performed comprehensive inspection of surge protection device mounted on exterior left side of residence and verified all electrical connections at main service panel located in garage. Conducted visual assessment of surge protector unit, checked indicator lights for proper operation, and tested electrical continuity through the device. Examined main electrical panel breakers and wiring connections for signs of surge damage or compromised components. Verified surge protector was properly grounded and all mounting hardware remained secure. Confirmed unit was functioning within normal operating parameters and providing adequate protection to electrical system. Documented current condition of surge protection equipment with photographic evidence of both exterior mounted components and interior panel connections for service records.

Completed fall maintenance on 5-year-old dual zone HVAC system located in walk-in attic. Performed comprehensive inspection of both zones, verifying proper operation of dual run capacitor replaced during previous spring maintenance and confirming ceiling saver float switch installed in auxiliary drain pan is functioning correctly. Replaced old Honeywell Home sensor component as documented in service photos. Conducted temperature readings across system, recording 52.5°F at measurement points to verify cooling performance. Inspected all accessible components on both sides of dual zone setup, checked electrical connections, evaluated airflow, and confirmed both zones are operating within normal parameters with no issues reported by homeowner.