Trusted HVAC Company in Hutto, TX

Removed and replaced builder grade pressure regulator and main shutoff valve with upgraded components connected to the irrigation system. Excavated access area and trimmed back hedge vegetation to reach existing equipment. Installed new brass pressure regulator and valve assembly with PVC connections configured in proper T-junction layout. Adjusted system pressure to optimal levels and purged all air from lines to ensure proper operation. Installed single large access vault to house both pressure regulator and shutoff valve for future maintenance accessibility. Backfilled excavation and secured all fittings to prevent leaks and ensure long-term system integrity.

Responded to no cooling complaint with thermostat set to 72°F but indoor temperature reading 83°F on a 6-year-old system. Upon arrival, performed diagnostic evaluation using Fieldpiece SDMN6 dual port manometer to measure static pressure and airflow parameters. Inspection revealed heavily contaminated condenser coil with significant accumulation of dirt, dust, and debris concentrated across the fin surfaces, restricting proper heat transfer and airflow. The buildup was impeding the unit's ability to reject heat effectively, resulting in reduced cooling capacity and elevated indoor temperatures. Documented equipment condition with photographs showing extent of contamination on coil assembly.

Conducted on-site assessment of existing water heating system for potential replacement with NAVIEN 240A tankless water heater. Inspected current State brand tank-type water heater installation in attic space, noting existing venting configuration with metal flue pipe and draft hood assembly. Evaluated existing plumbing connections including insulated hot and cold water lines and assessed pressure gauge readings on system. Documented current equipment condition, installation location, accessibility, and existing infrastructure including gas lines, water supply piping, and venting requirements. Photographed equipment and connections to provide accurate information for preparation of replacement estimate.

Responded to service call for visible cracking in walk-in shower pan. Performed thorough inspection of fiberglass/acrylic shower base and surrounding fixtures in combination tub-shower unit. Identified multiple surface stress cracks forming in shower pan material concentrated around the drain assembly. Upon further evaluation, determined cracking pattern consistent with inadequate substrate support beneath the pan, indicating presence of void space under the shower base. This lack of proper support causes flexing of the pan material under normal use, resulting in stress fractures at the surface level. Documented findings with photographic evidence showing crack locations and overall condition of shower surround, which includes molded-in shelf niches and brushed nickel fixtures. Shower pan exhibits structural compromise that will continue to worsen with continued use and may eventually lead to water intrusion and subfloor damage if left unaddressed.

Responded to water heater leak at 7-year-old residential property. Performed diagnostic pressure testing using calibrated gauge and brass fittings to assess system integrity and identify source of leak. Documented findings with photographic evidence for service records.

Completed spring maintenance on single HVAC system less than one year old located in attic of 19-year-old residence. Performed comprehensive inspection of system components, verified thermostat operation and calibration at 71°F, and inspected electrical connections at terminal bus bar assembly. Delivered replacement filter supply as requested and confirmed all system operations within normal parameters.