Trusted HVAC Company in Hutto, TX

Completed member maintenance on a 16-year-old HVAC system located in attic space. Accessed unit via pull-down attic ladder in garage area and performed comprehensive inspection of all system components. Verified proper operation of heating and cooling functions, inspected electrical connections at main service panel including furnace circuit and AC disconnect, checked refrigerant levels, examined condensate drain line for clogs, and replaced air filter. System is operating within normal parameters at this time, though age of equipment warrants continued monitoring given it has reached end of typical service life expectancy.

Removed defective zone control board from HVAC system in attic space and installed new REPNL700ZON ULTRA ZONE control panel with circuit board and wiring connections. Replaced faulty damper zone motor to restore proper zone control functionality. Verified all electrical connections, tested system operation, and confirmed proper communication between control board and zone dampers.

Responded to service call for 2018 Mitsubishi Electric mini-split system serving shop/weight room/golf simulator area with reported kinked refrigerant line issue. Performed diagnostic temperature measurements on indoor air handler unit, confirming adequate system performance with supply air temperature of 53.3°F and temperature differential of 22.5°F between return air (89.6°F) and discharge air (67.1°F), indicating proper cooling operation and no immediate refrigerant flow restrictions.

Responded to service call for visible wet spots on ceiling in 5-year-old residential property. Conducted comprehensive leak detection assessment to identify source of moisture intrusion affecting ceiling areas. Performed thorough inspection of bathroom plumbing fixtures, including vanity sink with undermount basin and chrome fixtures, standard toilet installation, and alcove-style bathtub with wall-mounted spout and faucet assembly. Examined all visible supply lines, drain connections, and fixture mounting points for signs of active leaks or moisture. Inspected tile surrounds, grout lines, and caulking joints around tub and shower area for potential water penetration. Assessed condition of fixtures and plumbing components to determine if leak source originated from bathroom plumbing system or alternative sources such as HVAC condensate lines or roofing issues requiring further investigation by appropriate trades.

Returned to site to complete HVAC ductwork installation and connections. Verified all metallic duct sections were properly secured with metal clamps, insulation was correctly positioned, and system components were ready for operation.

Responded to service call for breaker tripping issue at 22-year-old residential property. Conducted comprehensive electrical system inspection including main service panel, meter base, and associated breaker circuits. Evaluated Milbank meter enclosure and digital meter installation for proper operation and secure connections. Inspected exterior electrical components, conduit runs, and panel box for signs of wear, corrosion, or capacity concerns consistent with age of installation. Documented current system condition with photographic evidence showing meter assembly, service entrance equipment, and exterior electrical infrastructure. Identified tripping breaker and tested affected circuit for overload conditions, ground faults, and potential short circuits. Verified proper torque on all accessible connections and assessed overall panel capacity relative to current household electrical demand. Provided findings and recommendations regarding electrical system performance and long-term ser