Trusted HVAC Company in Hutto, TX

Responded to service call for inadequate hot water temperature from existing 6-year-old 80-gallon electric water heater that has never received maintenance. Inspected bathtub control valve and faucet assembly for proper operation and temperature mixing function. Performed pressure testing on water system to verify adequate supply pressure and identify any potential issues affecting hot water delivery. Evaluated current water heater performance and discussed replacement options with customer, who requested estimate for new 50-gallon tall electric water heater unit. Documented existing plumbing conditions including bathtub fixtures showing mineral deposit staining and water system pressure readings. Provided recommendations for water heater replacement to improve hot water availability and system efficiency.

Responded to tripped breaker causing loss of power to garage outlets after portable AC unit was plugged in. Inspected electrical panel located in garage, tested affected circuit breaker, and verified proper breaker operation. Evaluated garage outlet circuit load capacity and determined portable AC unit exceeded amperage rating for the existing 15-amp circuit, causing overload condition and breaker trip. Reset breaker and restored power to all garage outlets. Discussed electrical load requirements for portable AC equipment and recommended dedicated 20-amp circuit installation to safely support high-draw appliances and prevent future nuisance tripping.

Completed patio ceiling fan installation at 26-year-old residential property with 8-foot ceiling height. Removed existing non-rated electrical box and installed UL-listed fan-rated ceiling brace to support ceiling fan load. Utilized existing electrical power supply and connected fan to circuit, verified proper electrical connections and grounding at panel. Mounted and secured ceiling fan to fan-rated brace, tested all fan speeds and confirmed proper operation and balance.

Responded to service call for non-functioning garbage disposal with drainage issues in double-basin kitchen sink. Upon inspection, confirmed 6-year-old disposal unit had foreign objects (aquarium gravel) lodged in grinding chamber, causing complete blockage and preventing water drainage. Assessed unit for potential repair versus replacement given age and severity of obstruction. Removed disposal unit from mounting assembly, cleared impacted debris from grinding chamber and impeller mechanism, and inspected internal components for damage. Verified P-trap and drain line connections were clear of obstructions. Reinstalled disposal unit, tested operation and drainage flow, and confirmed proper function of both sink basins with no leaks at connections.

Completed member maintenance on 10-year-old HVAC system located in interior closet. Performed comprehensive system inspection and diagnostic testing of both indoor and outdoor units. Verified system operational status and measured electrical parameters using digital multimeter at outdoor unit, confirming proper voltage and amperage within manufacturer specifications. Inspected outdoor disconnect and noted previous issue with broken plastic handle on disconnect box. Checked refrigerant pressures, temperatures, and overall cooling performance. System currently operating within normal parameters with no immediate service concerns identified. Followed up on previously noted low static pressure on supply side from prior maintenance visit; conducted airflow assessment and verified blower operation. All safety controls and electrical connections tested and found secure. Unit maintaining adequate cooling capacity for 1,924 square foot residence with no reported hot or cold spots.

Responded to warranty call on 4-ton York heat pump system installed four months prior. Accessed attic installation to inspect and measure motorized dampers for proper sizing verification. Documented existing damper configurations and ductwork connections with photographs showing air handler unit, refrigerant lines, and associated ductwork. Obtained accurate measurements of dampers requiring replacement and submitted specifications to warehouse for parts ordering to resolve sizing issue under warranty coverage.