Trusted HVAC Company in Hutto, TX

Responded to follow-up service call for ongoing condensation issue on smaller 5-year-old Lennox system in attic serving master bedroom area of 3,511 square foot residence. Previous day's drain line work had not fully resolved water discharge from supply register, requiring additional diagnostic evaluation of air handler condensate management and ductwork insulation integrity. Inspected thermostat wiring connections and ceiling register assembly where moisture intrusion was evident, documented discoloration patterns around affected vent opening to determine source of continued condensation problem.

Completed complimentary bathroom remodel consultation for existing master bathroom featuring white subway tile walls, rectangular white bathtub, and black-framed glass shower enclosure with chrome fixtures. Assessed current bathroom configuration and documented existing conditions, noting the horizontal brick-pattern subway tile installation with light gray grout, wall-mounted tub faucet and spout, and light gray flooring. Provided detailed scope options for potential shower remodel work, including removal of existing tub and wall surrounds, installation of new tub or shower base, modifications to plumbing connections, shower pan installation, and tile work up to specified square footage requirements. Documented multiple remodel scenarios in solution guide with comprehensive step-by-step procedures for each scope level. Consultation builds on prior service history addressing leaking master shower, positioning for future remodel project with clear options and pricing tiers.

Responded to no cooling complaint on 2-year-old Lennox system located in attic. Performed comprehensive diagnostic evaluation of indoor air handler and outdoor condensing unit. Inspected electrical connections, tested capacitor performance, verified thermostat operation and wiring integrity, and checked refrigerant pressures and temperatures. System evaluation revealed minor issue affecting cooling performance, which was addressed during service call. Verified proper airflow through ductwork, confirmed condensate drainage functioning correctly, and tested system operation through complete cooling cycle. Unit restored to proper cooling operation with all components functioning within manufacturer specifications.

Responded to service call for water discharge from supply vent serving master bedroom on smaller of two attic-mounted air handler units. Previous contractor unable to diagnose issue. Upon inspection of 5-year-old system in accessible attic space, identified condensate drain line blockage causing overflow from primary drain pan. Cleared obstruction from condensate line, verified proper drainage and pan slope, and tested system operation under load. Performed amperage readings on outdoor condensing unit confirming compressor draw within manufacturer specifications. Inspected secondary air handler while on site and confirmed proper operation of both systems. All ductwork connections secure and insulation intact throughout attic installation.

Completed annual plumbing maintenance on 4-year-old gas tankless water heater located in garage, including full descaling flush using specialized pump and solution to remove mineral buildup and maintain optimal efficiency. Performed comprehensive water quality testing and system pressure verification, with all readings within normal operating parameters. Inspected and tested main water shutoff valve previously installed in September 2024, confirming proper operation with no residual issues or leaks detected from prior outdoor water leak incident.

Responded to master bathroom shower leak occurring when fixture was not in use. Diagnosed worn cartridge in the 6-year-old shower valve assembly that was failing to fully seat and seal in the closed position. Disassembled shower trim, removed defective cartridge, and installed new replacement cartridge with fresh O-rings and seals. Tested operation through multiple cycles to verify complete shutoff with no residual dripping or leaking. Also addressed kitchen garbage disposal making scraping noise during operation. Inspected grinding chamber and removed foreign object lodged in impeller assembly. Manually rotated flywheel using Allen wrench to confirm free movement and proper clearances. Ran disposal under water flow to verify normal operation and absence of abnormal sounds. Conducted water quality testing as part of routine plumbing system assessment.