Trusted HVAC Company in Hutto, TX

Completed first annual maintenance inspection on Friedrich 3.5-ton 14 SEER2 heat pump system installed approximately one year ago. Performed comprehensive tune-up including visual inspection of outdoor condensing unit, verified proper electrical connections at disconnect box, and confirmed refrigerant line set integrity. Measured and documented operating voltage at 156.7 volts. Inspected condenser coil fins for damage and debris accumulation, checked fan motor operation, and verified unit is level on concrete pad. Evaluated indoor air handler located in closet for proper airflow and filter condition. All system components operating within manufacturer specifications with no issues identified during this initial post-installation maintenance visit.

Successfully installed a complete 4-ton, 14 SEER2 two-stage heat pump system including outdoor condenser unit and indoor air handler. Fabricated and installed new supply and return air plenums equipped with manual dampers for zone control. Integrated IAQ 1000 air quality system into the new installation. Performed electrical testing and verification of system operation using calibrated multimeter to ensure proper voltage and capacitance readings. All equipment and installation work is backed by a comprehensive 10-year parts and labor warranty.

Completed spring maintenance on 5-year-old HVAC system located on second floor of residence. This visit served as critical follow-up to warranty evaporator coil replacement performed approximately 3.5 months prior, where system had experienced refrigerant leak. Performed comprehensive system inspection to verify no new leaks have developed and system is maintaining proper refrigerant charge following previous coil replacement and TXV installation. Conducted thorough cleaning of drain pan and blower assembly as part of seasonal maintenance protocol. Inspected all accessible components of indoor air handler unit. Verified system operational parameters including temperature differential across coil, airflow, and overall performance metrics. System demonstrated proper operation with no evidence of refrigerant loss or leak development since warranty repair. All components functioning within manufacturer specifications at time of service completion.

Responded to no cooling complaint on 11-year-old Carrier air conditioning system. Upon arrival, found outdoor condensing unit running but not producing adequate cooling. Performed diagnostic evaluation of electrical components and refrigeration system. Inspected dual-run capacitor rated at 40+5 MFD and contactor assembly within electrical compartment. Applied coil cleaner to outdoor condenser coil to remove accumulated dirt and debris affecting heat transfer efficiency. Verified all electrical connections at capacitor terminals and contactor were secure with no signs of overheating or failure. System operational at time of service completion.

Responded to service call for York 4-ton 14 SEER2 heat pump system not turning on, less than one year after installation. Upon arrival, inspected attic-mounted air handler (S/N: W2B6832666) and found unit operational with thermostat displaying cooling mode active and system running. Verified proper operation of condenser unit (S/N: SW2H5581054), checked refrigerant lines, and confirmed all electrical connections secure. System currently cycling normally and maintaining temperature setpoint, with thermostat showing 74°F and following programmed schedule.

Completed full HVAC system replacement including installation of YORK 5-ton 14 SEER2 single-speed condenser unit with new disconnect, wiring, and condenser pad, plus YORK upflow gas furnace in closet location with Wi-Fi thermostat, float switches, and new drain pan. Brazed and reinstalled refrigerant lines, pressure tested and charged system, rebuilt supply and return plenums, and installed Bronze package Polarized Media Air Cleaner at air handler base for 97% particulate filtration. Added two new duct runs with registers and grilles to back bedroom, repaired/replaced disconnected duct run to kitchen to restore proper airflow, and obtained all required permits. System includes 10-year parts and labor warranty coverage.