Trusted HVAC Company in Hutto, TX

Responded to service call for HVAC system experiencing random daily shutdowns with delayed restart capability until evening hours. Single system located in attic of residence built in 2004. Upon arrival, confirmed attic access was clear and safe for inspection. Performed comprehensive diagnostic evaluation of the main HVAC unit to identify root cause of intermittent shutdown issue. Conducted electrical testing using clamp meter to measure amperage draw and verify proper power supply to system components. Inspected capacitor, contactor, and associated wiring for signs of failure or degradation. Evaluated control board functionality and thermostat communication to rule out electrical or control system faults. Checked airflow through supply vents and confirmed vent registers were unobstructed and functioning properly. System had last received maintenance during summer season. Diagnostic findings documented through photographic evidence of electrical readings and system components. Ident

Responded to service call for multiple drain and toilet issues affecting both bathrooms in 2008-built residence. Customer reported gurgling toilets when shower was in use, slow shower drainage, and active leaking beneath both toilet fixtures, with symptoms persisting for approximately one week. Upon arrival, conducted comprehensive assessment of plumbing system to identify root causes of reported issues. Inspected both bathroom facilities to evaluate the extent of drainage problems and determine whether issues were isolated or systemic in nature. Addressed gurgling toilets and slow shower drainage by investigating potential main line obstruction and venting concerns. Given that both bathrooms were experiencing simultaneous symptoms, focused diagnostic efforts on main drain line as primary suspect. Evaluated drainage flow patterns and identified partial blockage affecting multiple fixtures throughout the home. Performed separate assessment of leaking toilets in both bathrooms. Conduc

Replaced two outdated fuse boxes in pantry with a new Eaton CH main lug panel featuring 24-32 spaces and all copper components to address hazardous melting screw terminal caused by doubled-up circuits and insufficient capacity. Installed 50A 240V 4-wire feeder circuit from main panel to new sub panel, replacing existing 3-wire feeder to properly separate neutral and ground bars for code compliance and protection of sensitive electronics. Reconnected grounding system by running #4 THHN wire from main panel to both existing ground rods with acorn lugs for proper termination. Installed whole home surge protection system rated for 108,000A to safeguard electrical infrastructure. All circuits in new sub panel were accurately identified and labeled using professional label maker for clear identification and future serviceability.

Responded to utility room sink leak in 12-year-old residential property. Upon arrival, conducted thorough inspection of under-sink plumbing and supply lines to identify leak source. Performed leak detection assessment to determine extent of water intrusion and checked surrounding areas including walls and flooring for hidden moisture damage. Completed repairs to eliminate active leak and verified all connections were secure and functioning properly.

Performed spot repair on exterior plumbing system, including pressure testing and inspection of water supply lines and associated fittings. Verified proper system pressure readings on gauge, examined brass connections for leaks, and ensured all outdoor plumbing components were functioning correctly per specifications.

Responded to callback for non-functional GFCI outlet in spare bathroom following previous day's extensive electrical service upgrade that included whole-home redevice with installation of 4 GFCI outlets. Troubleshot and tested GFCI receptacle, verified proper line/load connections, checked downstream devices on circuit, and restored full functionality to outlet and all devices on protected circuit.